新購 Basler acA2500-14gm 相機,使用從官方網站下載的 pylon v6 版本連接測試,報錯:
Type Time Source Message
Error 2019-09-06 10:18:25.196 Basler acA2500-14gm (23103410) Image acquisition on "Basler acA2500-14gm (23103410)" failed! Error: "The buffer was incompletely grabbed. This can be caused by performance problems of the network hardware used, i.e. network adapter, switch, or ethernet cable. To fix this, try increasing the camera's Inter-Packet Delay in the Transport Layer category to reduce the required bandwidth, and adjust the camera's Packet Size setting to the highest supported frame size."
處理措施:
一、使用版本V6 .0出錯率很高,更改為V5.2版本
V6.0 版本出錯率很高,可能新推出的原因,甚至界面都有卡頓現象出現。於是卸載后重新安裝V5.2,有很大改善。
二、使用版本V5.2版本穩定許多,但仍有報錯
V5.2 版本,盡管有所改善,但是也會偶爾有錯誤發生。這時需要改一些參數。
1. 打開巨型幀
2. 修改 Packet Size ,電腦不同,參數不同,在1500-9500之間嘗試,直到errors為0。可嘗試 9000。
3. 修改 Inter-Packet Delay,數值為 1500
三、保存設置
設置后,可通過 Configuration Sets -> User Set Save 保存。