<Huawei>sys
Enter system view, return user view with Ctrl+Z.
[Huawei]sys sw1
[sw1]dhcp enable
Info: The operation may take a few seconds. Please wait for a moment.done.
[sw1]vlan batch 10 20
[sw1]int g0/0/1
[sw1-GigabitEthernet0/0/1]port link-type access
[sw1-GigabitEthernet0/0/1]port default vlan 10
[sw1-GigabitEthernet0/0/1]int g0/0/2
[sw1-GigabitEthernet0/0/2]port link-type access
[sw1-GigabitEthernet0/0/2]port default vlan 20
[sw1-GigabitEthernet0/0/2]q
[sw1]int vlanif 10
[sw1-Vlanif10]ip add 192.168.10.1 24
[sw1-Vlanif10]q
[sw1]int vlanif 20
[sw1-Vlanif20]ip add 192.168.20.1 24
[sw1-Vlanif20]q
[sw1]ip pool net10 配置為vlan10分配IP地址的地址池，名為net10
[sw1-ip-pool-net10]network 192.168.10.0 mask 24
[sw1-ip-pool-net10]gateway-list 192.168.10.1
[sw1-ip-pool-net10]lease day 0 hour 2
[sw1-ip-pool-net10]dns-list 200.200.200.200
[sw1-ip-pool-net10]static-bind ip-address 192.168.10.254 mac-address 40B0-769F-9452 為固定mac分配固定ip（可省）
[sw1-ip-pool-net10]excluded-ip-address 192.168.10.250 192.168.10.253 不分配的ip地址（段），可省
[sw1-ip-pool-net10]q
[sw1]int vlanif 10
[sw1-Vlanif10]dhcp select global 啟用全局的地址池給DHCP客戶端,網關地址設置在哪個接口,就在哪個接口啟用全局地址池；這里特別注意dhcp服務配置在三層交換機和路由器上命令不同；
此時在pc1或pc2上通過命令：ipconfig即可查看到分配的ip地址
同樣在vlanif 20上配置net20地址池
[sw1-Vlanif10]q
[sw1]ip pool net20
[sw1-ip-pool-net20]network 192.168.20.0 mask 24
[sw1-ip-pool-net20]gateway-list 192.168.20.1
[sw1-ip-pool-net20]lease day 0 hour 2
[sw1-ip-pool-net20]dns-list 200.200.200.200
[sw1-ip-pool-net20]int vlanif 20
[sw1-Vlanif20]dhcp select global
此時在pc3或pc4通過命令：ipconfig即可查看到分配的ip地址；同時pc1也能ping通pc3