kali2020 網絡配置 中文字體 SSH登錄

 

網絡配置  vi /etc/network/interfaces 

# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface
auto lo
iface lo inet loopback


auto eth0
iface eth0 inet static 
address 192.168.147.11
gateway 192.168.147.2
netmask 255.255.255.0

DNS  vi /etc/resolv.conf 

localdomain
nameserver 8.8.8.8
nameserver 223.5.5.5
nameserver 114.114.114.114

重啟網絡 service networking restart 

重啟主機

 

eth0，eth1，eth2……代表網卡一，網卡二，網卡三……

lo 代表 127.0.0.1，即localhost

 

換源

#中科大
deb http://mirrors.ustc.edu.cn/kali kali-rolling main non-free contrib
deb-src http://mirrors.ustc.edu.cn/kali kali-rolling main non-free contrib
#阿里雲
#deb http://mirrors.aliyun.com/kali kali-rolling main non-free contrib
#deb-src http://mirrors.aliyun.com/kali kali-rolling main non-free contrib
#清華大學
#deb http://mirrors.tuna.tsinghua.edu.cn/kali kali-rolling main contrib non-free
#deb-src https://mirrors.tuna.tsinghua.edu.cn/kali kali-rolling main contrib non-free
#浙大
#deb http://mirrors.zju.edu.cn/kali kali-rolling main contrib non-free
#deb-src http://mirrors.zju.edu.cn/kali kali-rolling main contrib non-free
#官方源
#deb http://http.kali.org/kali kali-rolling main non-free contrib
#deb-src http://http.kali.org/kali kali-rolling main non-free contrib

配置源

vi /etc/apt/sources.list

更新軟件包和清除舊軟件緩存

apt update && apt-get clan

安裝中文字體

apt-get install ttf-wqy-zenhei

稍等

 

SSH登錄

vi /etc/ssh/sshd_config

PermitRootLogin prohibit-password改為 PermitRootLogin yes

#PasswordAuthentication yes，將前面的#去掉

 

 

啟動SSH服務，命令如下：

 /etc/init.d/ssh start或者service ssh start

  啟動SSH服務以后，通過如下命令來查看啟動是否成功：

/etc/init.d/ssh status或者service ssh status

 如果狀態為“active (running)”則表示服務在運行當中。

設置開機自動啟動

命令： update-rc.d ssh enable ，重新啟動。