修改hostname
vi /etc/hosts
127.0.0.1 localhost localhost.localdomain localhost4 localhost4.localdomain4 ::1 localhost localhost.localdomain localhost6 localhost6.localdomain6i 127.0.0.1 docker2 docker2為主機名
vi /etc/hostname
docker2
注意：這是修改配置文件的方式，可以用命令行的方式修改hostname
配置靜態的ip
vi /etc/sysconfig/network-scripts/ifcfg-eno16777736
TYPE=Ethernet
#BOOTPROTO=dhcp DEFROUTE=yes PEERDNS=yes PEERROUTES=yes IPV4_FAILURE_FATAL=no IPV6INIT=yes IPV6_AUTOCONF=yes IPV6_DEFROUTE=yes IPV6_PEERDNS=yes IPV6_PEERROUTES=yes IPV6_FAILURE_FATAL=no NAME=eno16777736 UUID=ca79f88e-e6ef-485f-93d9-671d4b49afaf DEVICE=eno16777736 #ONBOOT=no #static ip NM_CONTROLLED=no ONBOOT=yes BOOTPROTO=static HWADDR=00:0c:29:bf:c6:35 IPADDR=192.168.175.211 NETMASK=255.255.255.0 GATEWAY=192.168.175.2 DNS1=192.168.175.2 HWADDR為mac地址，可以不設置，如果要設置的話，可以先使用ip addr命令查看
- 重啟服務
service network restart，或者重啟主機reboot
修改網卡名稱為eth0
cd /etc/sysconfig/network-scripts/- 修改文件名
mv ifcfg-eno16777736 ifcfg-eth0 - 將
ifcfg-eth0中的DEVICE=eno16777736修改為DEVICE=eth0，這一步很重要，否則重啟服務service network restart會失敗報錯
ifcfg-eth0完整配置如下：
TYPE=Ethernet
#BOOTPROTO=dhcp DEFROUTE=yes PEERDNS=yes PEERROUTES=yes IPV4_FAILURE_FATAL=no IPV6INIT=yes IPV6_AUTOCONF=yes IPV6_DEFROUTE=yes IPV6_PEERDNS=yes IPV6_PEERROUTES=yes IPV6_FAILURE_FATAL=no NAME=eno16777736 UUID=ca79f88e-e6ef-485f-93d9-671d4b49afaf #DEVICE=eno16777736 #ONBOOT=no #static ip DEVICE=eth0 NM_CONTROLLED=no ONBOOT=yes BOOTPROTO=static HWADDR=00:0c:29:bf:c6:35 IPADDR=192.168.175.211 NETMASK=255.255.255.0 GATEWAY=192.168.175.2 DNS1=192.168.175.2 -
vi /etc/sysconfig/grub或者vi /etc/default/grub
添加net.ifnames=0 biosdevname=0
-
生成啟動菜單
grub2-mkconfig -o /boot/grub2/grub.cfg -
重啟系統生效
reboot
在centos7中繼續使用ifconfig命令
- 安裝net-tools
[root@docker2 default]# yum list|grep net-tools net-tools.x86_64 2.0-0.22.20131004git.el7 base [root@docker2 default]# yum -y install net-tools - 使用ifconfig命令
[root@docker2 default]# ifconfig eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.175.211 netmask 255.255.255.0 broadcast 192.168.175.255 inet6 fe80::20c:29ff:febf:c635 prefixlen 64 scopeid 0x20<link> ether 00:0c:29:bf:c6:35 txqueuelen 1000 (Ethernet) RX packets 11686 bytes 12134729 (11.5 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 3906 bytes 300355 (293.3 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 0 (Local Loopback) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 作者：對方不想理你並向你拋出一個異常
鏈接：https://www.jianshu.com/p/1d3388c88880
來源：簡書
簡書著作權歸作者所有，任何形式的轉載都請聯系作者獲得授權並注明出處。