在VMware的虛擬機中克隆CentOS，在重啟網卡的時候報錯：
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: Error: No suitable device found: no device found for connection 'System eth0'.
[FAILED]
解決辦法：
首先，打開/etc/udev/rules.d/70-persistent-net.rules內容如下面例子所示
# This file was automatically generated by the /lib/udev/write_net_rules
# program, run by the persistent-net-generator.rules rules file.
#
# You can modify it, as long as you keep each rule on a single
# line, and change only the value of the NAME= key.
# PCI device 0x8086:0x100f (e1000)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:0c:29:67:c5:e2", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
# PCI device 0x8086:0x100f (e1000)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:0c:29:75:d1:d7", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"
我們查看克隆源系統與克隆后中eth0的配置：
#cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE=eth0
HWADDR=00:0C:29:67:C5:E2
TYPE=Ethernet
UUID=5cb1d564-a7e8-4b57-bdb4-7e76e92f460a
ONBOOT=yes
NM_CONTROLLED=yes
BOOTPROTO=dhcp
可以看出，克隆的時候把網卡的MAC地址也克隆了，導致了有兩個系統有相同的MAC地址。
方法一、DEVICE=eth0改成DEVICE=eth1，然后HWADDR改成00:0c:29:75:d1:d7,然后把 ifcfg-eth0改名為ifcfg-eth1
方法二、在70-persistent-net.rules文件中把eth0的地址改成00:0c:29:75:d1:d7，同時把eth1的配置注釋掉，然后在ifcfg-eth0中修改HWADDR。
最后 service network restart即可。